Instrument Function
R&S
®
SMU200A
211Operating Manual 1007.9845.32 ─ 15
The output signals of the two RF signal paths (reference level is the set RF level) or any
freely selectable source can be measured.
The signal generator supports the use of R&S NRP power sensors for the acquisition of
level correction data. The acquired level correction data is used to create and activate
lists in which level correction values predefined by the user are freely assigned to RF
frequencies. Correction is performed by the user-defined table values being added to the
output level for the respective RF frequency (see chapter 5.5.9, "User Correction",
on page 223).
Please see your R&S NRP power sensor manual for detailed information on the used
power sensor.
5.5.6.1 NRP-Z Power Viewer Menu
To open the "NRP-Z Power Viewer" menu, select "RF/A Mod > Configure > NRP-Z Power
Viewer" or use the MENU key under "RF/A Mod".
The menu is structured like a table showing the values for sensor 1 in the left "column"
and the values of the second/third sensor in the middle/right "column". Only the detected
sensors are indicated, i.e. if only one sensor is connected only one column is indicated.
The sensor connected to the SENSOR port is always indicated as sensor 1, and the
sensors connected to the USB interface are always indicated as sensor 2 and 3.
Sensor - Power Sensors
Indicates the connector used for the detected sensors. The values listed below belong
to the respective sensor.
RF Signal and Analog Modulations - RF Block
To Next Page
Loading...
