Rohde & Schwarz SMU200A - Gui Update

Instrument Function
R&S
®
SMU200A
132Operating Manual 1007.9845.32 ─ 15
Firmware
The Firmware section of the menu shows the firmware version and the version of the
software platform.
Note: Your instrument is delivered with the latest firmware version available. Firmware
updates as well as the Release Notes describing the improvements and modifications
are provided on the Internet at the download site of the Rohde & Schwarz Signal gener-
ator home page. This home page always offers the latest information on your signal gen-
erator, e.g. also on changes of the firmware update procedure.
SCPI command:
n.a.
Hardware Options / Software Options
The tables in the sections "Hardware", "Software" and "WinIQSIM2" list the installed
hardware and software options.
"Option"
Short name of option
"Designation"
Name of Option
"Licenses"
Number of licenses.
The licenses for the software options are "floating licenses". This means
that in the case of two-path instruments just one license is required to
use the option for either of the two paths. However, two licenses must
be purchased to use an option on both paths simultaneously.
"Expiration
Date"
For regular options, "Permanent" is indicated in this column. Some
options are available as trial versions. This column shows their expiration
date. After this date, the option is no longer available on the instrument.
SCPI command:
*OPT?
*IDN?
Loaded Modules
Section "Loaded Modules" is provided for service purposes. It lists all loaded software
modules with their versions and offers a short description of each module.
SCPI command:
n.a.
5.2.3.4 Gui Update
The "Start/Stop Gui Update" dialog provides the possibility to switch off update of the
displayed parameters in order to increase speed for certain settings.
The indicated values are not updated and may therefore differ from the intern, used val-
ues.
General Instrument Settings