Rohde & Schwarz SMU200A - [:Source]:Bbin:oload:hold:reset; [:Source]:Bbin:oload:hold:state; [:Source]:Bbin:oload:state

Remote Control Commands
R&S
®
SMU200A
694Operating Manual 1007.9845.32 ─ 15
BBIN:OFFS:Q -0.1PCT
sets -0.1 %FS DC offset to the Q component of the external input
signal.
Example:
[:SOURce]:BBIN:OLOad:HOLD:RESet
This command executes a reset of the Overload Hold State and LED.
BBIN:MODE DIG
selects the digital baseband input mode.
BBIN:OLO:HOLD:RES
resets the overload hold state.
Example:
EventUsage:
[:SOURce]:BBIN:OLOad:HOLD:STATe?
This command queries an overload since the last reset for evaluating the measurement.
The Overload Hold state can be reset via the "Reset" command, or is reset automatically
by starting a new measurement ("Auto Level Set") or by setting new values (Crest Factor,
PEP, Level).
Return values:
0|1|OFF|ON<State>
BBIN:MODE DIG
selects the digital baseband input mode.
BBIN:OLO:HOLD:STAT?
queries the overload state.
Response: 0
the AC/DC converter has not been overloaded.
Example:
Query onlyUsage:
[:SOURce]:BBIN:OLOad:STATe?
This command queries the current overload state of the A/D converter.
Return values:
0|1|OFF|ON<State>
BBIN:MODE DIG
selects the digital baseband input mode.
BBIN:OLO:STAT?
queries the overload state.
Response: 0
The AC/DC converter is not overloaded.
Example:
Query onlyUsage:
SOURce Subsystem