Rohde & Schwarz SMU200A - Output<Hw>:Afixed:range:upper; Output<Hw>:Amode

Remote Control Commands
R&S
®
SMU200A
553Operating Manual 1007.9845.32 ─ 15
Return values:
float
dBm
<Lower>
Default unit:
OUTP:AFIX:RANG:LOW
queries the minimum level for the FIXed setting.
Response: -50
The minimum level is -50 dBm.
Example:
Example:
Query onlyUsage:
:OUTPut<hw>:AFIXed:RANGe:UPPer?
The command queries the maximum level which can be set without the attenuator being
adjusted (Attenuator FIXed).
Return values:
float
dBm
<Upper>
Default unit:
OUTP:AFIX:RANG:UPP
queries the maximum level for the FIXed setting for the RF output.
Response: -27
The maximum level is -27 dBm.
Example:
Example:
Query onlyUsage:
:OUTPut<hw>:AMODe <Amode>
The command switches the mode of the attenuator at the RF output (Attenuator MODe).
OUTPut Subsystem