Rohde & Schwarz SMU200A - Connecting a Monitor

Preparing for Use
R&S
®
SMU200A
40Operating Manual 1007.9845.32 ─ 15
"Add Printer" wizard on the "Start > Settings > Printer and Faxes" menu to install the
driver. To access Windows XP, press the Windows key on the external keyboard.
2.4.2 Connecting a Monitor
An external monitor with an analog interface can be connected to the MONITOR con-
nector on the rear panel of the instrument. Per default, the external monitor connector is
disabled and has to be enabled before operation.
Connecting external devices
Before connecting any external device such as a monitor, make sure that the instrument
is switched off (or in standby mode). Otherwise, correct operation cannot be assured.
This does not apply to USB devices.
1. Shut down the instrument.
None of the front-panel LEDs should be on.
2. Plug in the monitor cable to the MONITOR connector on the rear panel of the instru-
ment.
3. Start up the instrument.
The green LED must be on.
The external monitor is detected.
The entire display of the instrument, containing the status bar, the block diagram and
the winbar is displayed on the monitor additionally. Further settings are not required.
The MONITOR interface is described in "Appendix A: Hardware Interfaces" in the Oper-
ating Manual.
2.5 Windows Operating System
The instrument contains the Windows XP operating system. To ensure that the instru-
ment software functions properly, certain rules must be adhered to concerning the oper-
ating system.
Windows Operating System