Remote Control Commands
R&S
®
SMU200A
504Operating Manual 1007.9845.32 ─ 15
{WAVEFORM-Length: #I0Q0I1Q1...IxQx...IN-1QN-1…}
(mandatory for waveforms)
The tag contains the actual waveform data or multi segment waveform data (I/Q stream).
The TYPE tag decides, wheather the waveform file contains a normal waveform or a multi
segment waveform.
The following figure shows the prinziple of multi segment work mode.
At 50 Ohm between the inner and outer conductors of the I and Q outputs, an amplitude
Vp of +/-0.5 Volt arises on the I/Q output connectors of the R&S SMU. The illustration
also applies to the Q output.
R&S Signal Generator Waveform and List Format
To Next Page
Loading...
