Rohde & Schwarz SMU200A - Bert:start; Bert:state; Bert:stop; Bler:start

Remote Control Commands
R&S
®
SMU200A
521Operating Manual 1007.9845.32 ─ 15
Return values:
<Type>
BLER:SET:TYPE
queries the type of measurement.
Response: CRC16
Example:
Example:
Query onlyUsage:
:BLER:STARt
:BERT:STARt
Starts a continuous measurement.
These commands automatically set BERT:SEQuence or BLER:SEQuence to AUTO and
BERT:STATe or BLER:STATe to ON.
BERT:STAR
starts a continuous measurement.
Example:
EventUsage:
:BLER:STATe <State>
:BERT:STATe <State>
Switches the measurement on/off. Depending on the selected mode, either a continuous
measurement (BERT|BLER:SEQ AUTO) or a single measurement (BERT|BLER:SEQ
SING) is carried out. A single measurement must be triggered (:TRIG:BERT|BLER).
These commands are automatically set to ON by BERT:STARt or BLER:STARt and to
OFF by BERT:STOP or BLER:STOP.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
BERT:SEQ SING
selects a single measurement.
BERT:STAT ON
switches the BER measurement on.
TRIG:BERT
starts a single measurement.
Example:
Example:
:BLER:STOP
:BERT:STOP
Stops an ongoing measurement.
These commands automatically set BERT:STATe or BLER:STATe to OFF
.
BERT and BLER Subsystems