Getting Started
R&S
®
SMU200A
77Operating Manual 1007.9845.32 ─ 15
Note: For modulation modes that can be simultaneously used, refer to the R&S SMU
data sheet.
RF/A Mod B
In this block, settings are made for analog modulation and RF parameters of path B. This
block is displayed only if a second RF path is installed.
Available analog modulation modes:
●
Amplitude modulation
●
Pulse modulation.
3.5 Example of Setup
This section provides an example on how to configure the instrument to generate and
display a simple QPSK-modulated signal.
Configuring and displaying a QPSK-modulated signal
To generate and display a QPSK-modulated signal, proceed as follow:
1. Activate default (preset) state.
Press the PRESET key to set a defined instrument state.
2. Select and activate digital modulation
Example of Setup
To Next Page
Loading...
