Manual Operation
R&S
®
SMU200A
105Operating Manual 1007.9845.32 ─ 15
4.5 Editors
The R&S SMU provides user-friendly editors for defining data lists as well as control and
marker signals.
Lists containing frequency and level value pairs are used for the list mode and the user-
defined level correction.
Internally generated data lists can be used for digital modulation and digital standards;
the same applies to internally defined control and marker signals. The lists are saved to
files and may thus have any length. The file name of the lists and the directory to which
the files are saved are user-selectable. The file prefix is different for each list type and is
permanently assigned by the system.
For information about file handling and overview of the automatically assigned file pre-
fixes, refer to chapter 4.7, "File Management", on page 113.
4.5.1 Working with List Editor
The "User Correction" and "List Mode" dialogs provide a list editor for defining the fre-
quency/level value pairs.
Editing list mode data lists
1. To access a list editor and open an existing data list for editing, use the cursor keys
to select the associated button "Edit User Correction Data..." or "Edit List Mode
Data..." in the individual menu.
The selected list is displayed and the cursor marks the first row of the "Frequency/
Hz" column.
If no list has been selected, a blank list of only one row is displayed.
2. Press the LEFT/RIGHT arrow keys to change between the colums.
Use the UP/DOWN arrow keys to mark a row.
Editors
To Next Page
Loading...
