Rohde & Schwarz SMU200A - Source:bb:arb:wseg Subsystem

Remote Control Commands
R&S
®
SMU200A
614Operating Manual 1007.9845.32 ─ 15
Return values:
<waveform filename><Points>
BB:ARB:WAV:POINt?
queries the number of I/Q values pairs in the waveform file.
Response: 401
the waveform file contains 401 I/Q values pairs.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:ARB:WAVeform:SELect <Select>
The command selects the waveform file. If the file is not on the default path, the path
must be specified at the same time. If no file of the specified name exists, it is created.
The file extension may be omitted. Only files with the file extension *.wv will be created
or loaded.
Parameters:
string<Select>
BB:ARB:WAV:SEL 'D:/user/wave1.wv'
selects waveform file 'wave1.wv' from the D:/user directory and
loads it..
BB:ARB:TRIG:SEQ AAUT
sets trigger mode Armed_Auto.
BB:ARB:TRIG:SOUR INT
selects internal triggering.
BB:ARB:STAT ON
switches on the ARB generator.
BB:ARB:TRIG:EXEC
starts generating the selected waveform.
Example:
[:SOURce<hw>]:BB:ARB:WAVeform:TAG?
The commandqueries the content of the specified tag of the selected Waveform file file
(see chapter 7.3, "R&S Signal Generator Waveform and List Format", on page 496).
Return values:
string<Tag>
BB:ARB:WAV:TAG? 'comment'
queries the content of the 'comment' tag.
Response: "Sine wave for test purposes"
Example:
Query onlyUsage:
SOURce:BB:ARB:WSEG Subsystem
The WSEGment subsystem contains the commands for setting the Multi Segment Wave-
form Generator.
SOURce Subsystem