Rohde & Schwarz SMU200A - Format Subsystem

Remote Control Commands
R&S
®
SMU200A
530Operating Manual 1007.9845.32 ─ 15
DISP:PSAV:HOLD 10
sets the wait for the screen saver mode to 10 minutes.
Example:
:DISPlay:PSAVe[:STATe] <State>
This command activates/deactivates the screen-save mode of the display. With the
screen-save mode activated the display including backlight is completely switched off
after the elapse of the wait time (see command DISPlay:PSAVe:HOLDoff) when no
entries via front panel, external mouse or external keyboard are made.
This mode is recommended for preserving the display especially if the instrument is
exclusively operated via remote control.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
DISP:PSAV ON
activates screen saver mode.
Example:
7.9 FORMat Subsystem
The FORMat subsystem contains the commands which determine the format of the data
that the R&S SMU returns to the controller. This affects all query commands which return
a list of numerical data or block data. Reference is made to this in the descriptions of the
commands.
For two-path instruments, the data format is set simultaneously for both paths.
:FORMat:BORDer..........................................................................................................530
:FORMat[:DATA]............................................................................................................531
:FORMat:SREGister.......................................................................................................531
:FORMat:BORDer <Border>
The command determines the sequence of bytes within a binary block. This only affects
blocks which use the IEEE754 format internally.
FORMat Subsystem