Rohde & Schwarz SMU200A - LXI Browser Interface

Preparing for Use
R&S
®
SMU200A
60Operating Manual 1007.9845.32 ─ 15
Firmware update
After a firmware update, shut-down and re-start the instrument in order to enable the full
LXI functionality.
Default state of the network settings
According to the LXI standard, an LCI must set the following parameters to a default state.
Parameter Value
TCP/IP Mode DHCP + Auto IP Address
Dynamic DNS Enabled
ICMP Ping Enabled
Password for LAN configuration LxiWebIfc
The LCI for the R&S SMU also resets the following parameters:
Parameter Value
Hostname <Instrument-specific host name>
Description Vector Signal Generator
Negotiation Auto Detect
VXI-11 Discovery Enabled
The LAN settings are configured using the instrument's "LXI Browser Interface".
2.9.1 LXI Browser Interface
The instrument's LXI browser interface works correctly with all W3C compliant browsers.
Typing the instrument's host name or IP address in the address field of the browser on
your PC, e.g. http://10.113.10.203, opens the "Instrument Home Page" (welcome page).
Do not add the missing zeros in the IP address, while opening the Instrument Home Page.
LXI Configuration