Rohde & Schwarz SMU200A - Clock Settings; [:Source<Hw>]:Bb:DM:state; [:Source<Hw>]:Bb:DM:switching:source; [:Source<Hw>]:Bb:DM:switching:state

Remote Control Commands
R&S
®
SMU200A
624Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:DM:STATe <State>
The command enables or disables digital modulation. Switching on digital modulation
turns off all the other digital standards.
Enabling digital modulation (BB:DM:STAT ON) turns off all the other standards.
In case of two-path instruments, this affects the same path.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
BB:DM:STAT ON
switches digital modulation on.
Example:
[:SOURce<hw>]:BB:DM:SWITching:SOURce <Source>
The command selects the source of the CW control signal for switching between a modu-
lated and an unmodulated signal.
Parameters:
INTernal | EXTernal
INTernal
The CW signal in the control list is used for the control.
The internal signal can be output on one of the user interfaces.
EXTernal
The control signal on the CW pin of the AUX I/Q connector is used.
In case of two-path instruments, path A and B.
INTernal
<Source>
*RST:
BB:DM:SWIT INT
the CW signal in the control list is used for the control.
Example:
[:SOURce<hw>]:BB:DM:SWITching:STATe <State>
The command enables switching between a modulated and an unmodulated signal.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
BB:DM:SWIT:STAT INT
CW switching is active.
Example:
Clock Settings
[:SOURce<hw>]:BB:DM:CLOCk:MODE............................................................................625
[:SOURce<hw>]:BB:DM:CLOCk:MULTiplier......................................................................625
[:SOURce<hw>]:BB:DM:CLOCk:SOURce........................................................................626
SOURce Subsystem