Instrument Function
R&S
®
SMU200A
148Operating Manual 1007.9845.32 ─ 15
The instrument does not recognize any device connected to the USB interface when the
interface is disabled.
The setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
SCPI command:
n.a.
LAN Connection
Enables/disables the LAN interfaces.
It is not possible to access the instrument via LAN while the LAN connection is disabled.
The setting requires the entry of the security password and is only accepted after the
"Accept" button is pressed.
SCPI command:
n.a.
Security Password
Enters the password that is required to enable or to disable the settings protected by a
security password. Default is '123456'.
Note: It is highly recommended to change the default security password before connect-
ing the instrument to the network.
All settings are only accepted after the "Accept" button is pressed.
SCPI command:
n.a.
Accept - Security
Accepts a new entry or selection and changes the settings accordingly.
SCPI command:
n.a.
Bluetooth Pin
Requires a USB Bluetooth adapter (recommended extra, see data sheet).
Enters the Bluetooth pin of an external Bluetooth device. The pin is required to enable
remote control via an external Bluetooth device.
SCPI command:
n.a.
5.2.3.17 Save/Recall
The"Save/Recall "submenu can also be called up with the FILE key and is therefore
described in the section on this key (see chapter 5.2.8, "Storing and Loading Instrument
Data - File Key", on page 156).
5.2.3.18 Factory Preset
The "Factory Preset" dialog provides a function to reset the instrument's settings to their
factory state. This function is activated by pressing the "Execute Factory Preset" button.
General Instrument Settings
To Next Page
Loading...
