Rohde & Schwarz SMU200A - A.2 Monitor Connector (MONITOR)

Hardware Interfaces
R&S
®
SMU200A
838Operating Manual 1007.9845.32 ─ 15
Pin Signal Description
39 USER 3 USER input/output which can be configured for various purposes.
40 USER 4 USER input/output which can be configured for various purposes.
41 MARKER 3 Output for the freely programmable marker signal 3 of Path A. The output is
permanently assigned.
42 MARKER 2 B Output for the freely programmable marker signal 2 of Path B.
43 MARKER 3 B Output for the freely programmable marker signal 3 of Path B. The output is
permanently assigned.
44 not used not used
45 BURST Signal input/output for controlling the burst ramp.
For two-path instruments, the signal for Path B can be applied to one of the
USER interfaces.
With external envelope curve control ("Custom Digital Modulation" only), the
pin is the input for the control signal "BURST_RAMP".
With internal envelope curve control, the control signal "BURST_RAMP" is
output for Path A.
46 EXT TUNE Tuning input for the internal reference frequency.
47 BITCLK Output Bit clock for internal mode.
For two-path instruments, the signal for Path B can be applied to one of the
USER interfaces.
48 USER 2 USER input/output which can be configured for various purposes.
49 SYMBCLK Symbol clock output for internal mode.
With two-path instruments, the signal for Path B can be applied to one of the
USER interfaces.
50 not used not used
A.2 Monitor Connector (MONITOR)
The 15-pin Sub-D female connector MONITOR at the rear panel is intended for connect-
ing an external VGA monitor.
Table 1-2: Pin assignment of the MONITOR connector
Monitor Connector Pin Signal Pin Signal Pin Signal
1 Red (output) 6 GND 11 (NC)
2 Green (output) 7 GND 12 (NC)
3 Blue (output) 8 GND 13 HSYNC (output)
4 (NC) 9 GND 14 VSYNC (output)
5 GND 10 GND 15 (NC)
Monitor Connector (MONITOR)