Rohde & Schwarz SMU200A - Display Subsystem

Remote Control Commands
R&S
®
SMU200A
529Operating Manual 1007.9845.32 ─ 15
DIAG:BGIN:CAT
queries the names of the assemblies.
Response: MBRD,SSYN,IQOP3,IQOP3_LCM,....
Example:
Query onlyUsage:
:DIAGnostic:INFO:OTIMe?
The command queries the number of operation hours.
Return values:
float<OTIMe>
DIAG:INFO:OTIM
queries the operation hours.
Response: 100023
The instrument was operated for 100023 hours up to now.
Example:
Query onlyUsage:
:DIAGnostic:INFO:POCount?
The command queries the number of power-on events.
Return values:
float<Pocount>
DIAG:INFO:POC
queries the number of power on events.
Response: 123
The instrument was switched on for 123 times up to now.
Example:
Query onlyUsage:
7.8 DISPlay Subsystem
The DISPlay system contains the commands to set the power-save mode of the instru-
ment.
:DISPlay:PSAVe:HOLDoff <Holdoff>
This command sets the wait time for the screen-save mode of the display. The available
value range is 1 to 60 minutes, the resolution 1 minute. The entry is dimensionless.
Parameters:
float
1 to 60
1
minute
<Holdoff>
Range:
*RST:
Default unit:
DISPlay Subsystem