Rohde & Schwarz SMU200A - [:Source<Hw>]:Correction:cset:data:frequency; [:Source]:Correction:cset:catalog

Remote Control Commands
R&S
®
SMU200A
699Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:CORRection:CSET:DATA:POWer:MLEVel:STATe....................................701
[:SOURce<hw>]:CORRection:CSET:DATA[:SENSor<ch>][:POWer]:SONCe........................702
[:SOURce]:CORRection:CSET:DELete............................................................................702
[:SOURce<hw>]:CORRection:DEXChange:AFILe:CATalog................................................702
[:SOURce<hw>]:CORRection:DEXChange:AFILe:EXTension.............................................703
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SELect..................................................703
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:COLumn................................704
[:SOURce<hw>]:CORRection:DEXChange:AFILe:SEParator:DECimal................................704
[:SOURce<hw>]:CORRection:DEXChange:EXECute.........................................................705
[:SOURce<hw>]:CORRection:DEXChange:MODE............................................................705
[:SOURce<hw>]:CORRection:DEXChange:SELect............................................................706
[:SOURce<hw>]:CORRection:CSET[:SELect]...................................................................706
[:SOURce<hw>]:CORRection:MLEVel:STATe...................................................................707
[:SOURce<hw>]:CORRection[:STATe].............................................................................707
[:SOURce<hw>]:CORRection:VALue...............................................................................707
[:SOURce]:CORRection:CSET:CATalog?
The command requests a list of user correction tables. The individual lists are separated
by commas.
The lists are stored with the fixed file extensions *.uco in a directory of the user's choice.
The directory applicable to the commands is defined with the command
MMEMory:CDIR.
Return values:
string<Catalog>
MMEM:CDIR 'D:/Lists/ucor'
selects the directory for the user correction files.
CORR:CSET:CAT?
queries which correction tables are available.
Response:UCOR1,UCOR2,UCOR3
the correction tables UCOR1, UCOR2 and UCOR3 are available.
Example:
Query onlyUsage:
[:SOURce<hw>]:CORRection:CSET:DATA:FREQuency <Frequency>
The command transfers the frequency data to the table selected
with :CORRection:CSET:SELect.
The numerical suffix at SOURce must not be used for this command.
Parameters:
string
300 kHz to RFmax (depending on model)
Hz
<Frequency>
Range:
Default unit:
SOURce Subsystem