Rohde & Schwarz SMU200A - [:Source<Hw>]:Bb:arb:wsegment:next:execute; [:Source<Hw>]:Bb:arb:wsegment:next:source; [:Source<Hw>]:Bb:arb:wsegment:sequence:append

Remote Control Commands
R&S
®
SMU200A
619Operating Manual 1007.9845.32 ─ 15
MMEM:CDIR 'D:/user/waveform'
sets the default directory to root/user/waveform.
BB:ARB:WSEG:NEXT 2
selects segment 2 to be output.
BB:ARB:TRIG:SMOD NEXT
selects extended trigger mode next, i.e. the segment specified with
command :BB:ARB:WSEG:NEXT will be output.
BB:ARB:SEQ AUTO
selects trigger mode Auto.
BB:ARB:WAV:SEL 'multi_wv1'
loads multi segment waveform multi_wv1.wv. Generation of
segment 2 starts.
BB:ARB:WSEG:NEXT 3
switched at once to output of segment 3.
Example:
[:SOURce<hw>]:BB:ARB:WSEGment:NEXT:EXECute
Triggers manually switchover to the subsequent segment in the mutli segment file. A
manual trigger can be executed only when an internal next segment source
(BB:ARB:WSEG:NEXT:SOUR INT) has been selected.
To perform a switchover to any segment within the multi segment file, select the next
segment with the command BB:ARB:WSEG:NEXT.
This command is disabled, if a sequencing play list is enabled.
BB:ARB:WSEG:NEXT:SOUR INT
selects internal next segment source.
BB:ARB:WSEG:NEXT 2
selects segment 2 to be output.
BB:ARB:WSEG:NEXT:EXEC
executes a switchover to the next segment.
Example:
EventUsage:
[:SOURce<hw>]:BB:ARB:WSEGment:NEXT:SOURce? <Source>
Queries the next segment source.
BB:ARB:WSEG:NEXT:SOUR?
queries the next segment source.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:ARB:WSEGment:SEQuence:APPend <State>, <Segment>,
<Count>, <Next>
Appends a new segment to the selected sequencing play list.
SOURce Subsystem