Rohde & Schwarz SMU200A - Front Panel Connectors

Preparing for Use
R&S
®
SMU200A
25Operating Manual 1007.9845.32 ─ 15
ROTARY KNOB
The rotary knob has several functions:
●
Increases (clockwise direction) or decreases (counter-clockwise direction) numeric
values at a defined step width in editing mode
●
Moves the cursor, e.g. to a function block in the block diagram
●
Scrolls within lists, tables or tree views
●
Acts like the ENTER key, when it is pressed.
●
Shifts the selection bar within focused areas (e.g. lists), if the edit mode is activated.
Note: Turning or pressing the rotary knob is equivalent to pressing the UP and DOWN
keys or the ENTER key in the keypad.
NAVIGATION KEYS
The navigation keys consist of 4 arrow keys which are used for navigation, alternatively
to the rotary knob.
UP/ DOWN
KEYS
The up and down arrow keys do the following:
●
In a numeric edit dialog box, increase or decrease the instrument
parameter.
●
In a list, table, window or dialog box, scroll vertically.
LEFT/ RIGHT
KEYS
The left and right arrow keys do the following:
●
In an alphanumeric edit dialog box, move the cursor forward and
back.
●
In a list, table, wondiw or dialog box, scroll horizontally.
2.1.7 Front Panel Connectors
The RF and I/O connectors and various additional interface connectors are located on
the front panel.
I , Q
I and Q inputs for external analog modulation signal in case of I/Q modulation.
This inputs are also used for external analog baseband signal (option R&S SMU-B17,
Baseband Input).
For more information see:
●
chapter 5.8.2, "Data and Signal Sources in Baseband", on page 327
●
chapter 5.9.1.1, "Baseband Input Settings Menu", on page 438
DATA
Signal for Path A only.
Input for external serial data signal in case of digital modulation.
Output for serial data signal in case of digital modulation.
For more information see:
●
chapter 5.8.2, "Data and Signal Sources in Baseband", on page 327
●
chapter 5.9.1.1, "Baseband Input Settings Menu", on page 438
Front Panel Tour