Rohde & Schwarz SMU200A - User Marker; aux I;O Settings

Instrument Function
R&S
®
SMU200A
140Operating Manual 1007.9845.32 ─ 15
Screen Saver Active
Activates/deactivates the screen-save mode of the display.
If activated, the display including backlight is completely switched off after the elapse of
the "Wait Time" when no entries via front panel, external mouse or external keyboard are
made.
This mode is recommended for preserving the display especially if the instrument is
exclusively operated via remote control.
SCPI command:
:DISPlay:PSAVe[:STATe] on page 530
Wait Time
Enters the idle time that must elapse before the display lamp is shut off when no entries
are made.
SCPI command:
:DISPlay:PSAVe:HOLDoff on page 529
Help Language
Selects the help language.
The online help is provided in English and Chinese.
SCPI command:
n.a.
Layout - Setup
Selects the keyboard layout for the selected keyboard language.
The assignment of some keys depends on the selected layout and language.
SCPI command:
:KBOard:LAYout on page 541
:KBOard:LANGuage on page 541
5.2.3.12 User Marker / AUX I/O Settings
The R&S Signal Generator provides four "USER" interfaces which can be freely assigned
a selection of signals and which can be configured as both inputs and outputs.
The following table gives an overview of the signals that can be applied at the USER
connector.
For two-path instruments, these signals are available for Path A or B.
General Instrument Settings