Rohde & Schwarz SMU200A - Display;Keyboard Settings

Instrument Function
R&S
®
SMU200A
139Operating Manual 1007.9845.32 ─ 15
Baseband Trigger Input Slope
Selects the polarity of the active slope of an externally applied trigger signal.
This setting affects the TRIGGER inputs (BNC connectors).
SCPI command:
[:SOURce]:INPut:TRIGger:BBANd:SLOPe on page 721
Instrument Trigger Input Slope
Sets the polarity of the active slope of an applied instrument trigger.
In the case of two-path instruments this setting is valid for both paths.
It affects the INSTR TRIG for path A and the INST TRIG B input of the AUX I/O interface
for path B.
SCPI command:
[:SOURce]:INPut:TRIGger:SLOPe on page 723
Clock Input Slope
Sets the polarity of the active slope of an externally applied bit clock pulse or symbol clock
pulse.
This setting affects the CLOCK input (BNC connector).
An external clock signal can only be supplied for Path A.
SCPI command:
:CLOCk:INPut:SLOPe on page 526
Clock Output Source
Indicates the path for which the clock signal at the CLOCK OUT connector is to be output
(always Path A).
This setting is only possible for two-path instruments.
SCPI command:
:CLOCk:OUTPut:SOURce on page 527
Clock Output Mode
Sets the output of bit or symbol clock pulses at the CLOCK OUT connector at the rear
panel.
SCPI command:
:CLOCk:OUTPut:MODE on page 527
5.2.3.11 Display/Keyboard Settings
In the "Display/Keyboard Settings" menu the power-save mode and external keyboard
settings are made. It is opened using the SETUP or MENU key under "Environment".
General Instrument Settings