Rohde & Schwarz SMU200A - Alphabetical List of R&S SMIQ Commands

Remote Control Commands
R&S
®
SMU200A
803Operating Manual 1007.9845.32 ─ 15
Parameters:
DEG|RAD
RAD
<Angle>
*RST:
UNIT:ANGL DEG
sets default unit DEG for all commands which determine angle
values.
Example:
SCPI conformUsage:
:UNIT:POWer <Power>
The command defines the default unit for power. It is valid for all commands which deter-
mine power values. It does not influence the manual control parameter unit and the dis-
play.
Parameters:
V|DBUV|DBM
DBM
<Power>
*RST:
UNIT:POW V
sets default unit V for all commands which determine power val-
ues.
Example:
SCPI conformUsage:
7.21 Alphabetical List of R&S SMIQ Commands
The table lists the commands of the R&S SMIQ in the "R&S SMIQ command column"
and describes their function in the "Short description" column. The symbol "X" in the "R&S
SMU" column indicates that the command is also implemented in the R&S SMU. Differ-
ences between the two sets of commands are specified in the "Remarks" column.
R&S SMIQ Command Short description R&S
SMU
Remarks
ABORt:...
Reset
ABORt[:SWEep]
Reset sweep X
ABORt:LIST
Reset list mode X
BERT:...
Bit Error Rate Measurement
BERT:RESult?
Result of the bit error rate mea-
surement
X
BERT:SEQuence
BERT Mode X
BERT:SETup:CLOCk[:
POLarity]
Polarity of the active clock
slope
X
BERT:SETup:DATA[:POLarity]
Polarity of the active clock
slope
X
Alphabetical List of R&S SMIQ Commands