Rohde & Schwarz SMU200A - Mmemory:rdirectory; Mmemory:store:state

Remote Control Commands
R&S
®
SMU200A
551Operating Manual 1007.9845.32 ─ 15
Setting only
SCPI conform
Usage:
:MMEMory:MSIS <Msis>
The command sets the drive (or network resource in the case of networks) using msus
(MSIS = Mass Storage Identification String). This setting is effective for all MMEMory
commands where the drive is not explicitly specified in the parameter.
Parameters:
string
D:\
<Msis>
*RST:
MMEM:MSIS 'E:'
selects the memory stick as the default drive.
Example:
SCPI conformUsage:
:MMEMory:RDIRectory <Rdirectory>
Removes an existing directory from the mass memory storage system. If no directory is
specified, the subdirectory with the specified name is deleted in the default directory.
Setting parameters:
string
String parameter to specify the directory to be deleted.
<Rdirectory>
MMEM:RDIR 'carrier'
deletes the subdirectory 'carrier' in the current directory.
Example:
Setting onlyUsage:
:MMEMory:STORe:STATe <sav_rcl_state_number>, <file_name>
Stores the current instrument setting in the specified file.
The instrument setting must first be stored in an internal memory with the same number
using the common command *SAV.
Setting parameters:
<integer>
Corresponds to the specific <number> defined with the *SAV
command, e.g. *SAV 4.
<string>
String parameter to specify the file name with extension
*.savrcl.
<sav_rcl_state_numb
er>
<file_name>
MMEMory Subsystem