Preparing for Use
R&S
®
SMU200A
27Operating Manual 1007.9845.32 ─ 15
SENSOR
Connector for R&S NRP-Zxx sensors.
With the aid of the "User Correction" function, a table with correction values for external
test assemblies can be automatically determined, e.g. for compensating the frequency
response of cables.
The power sensors are connected by inserting the male connector. To disconnect hold
the connector by its sleeve. Pulling on the sensor cable will not release the sensor con-
nector.
See also chapter 5.5.6, "NRP-Z Power Viewer", on page 210.
2.2 Rear Panel Tour
This section gives an overview of connectors on the rear panel of the instrument. Each
connector is briefly described and a reference is given to the chapters containing detailed
information. For technical data of the connectors refer to the data sheet.
If a connector of a two-path instrument is available for one path only (e.g. path A) or for
either of the two (path A or B), a note is made in the brief description.
For more detailed information, refer to the corresponding description in the Operating
Manual.
Fig. 2-2: Rear panel view
Rear Panel Tour
To Next Page
Loading...
