Instrument Function
R&S
®
SMU200A
157Operating Manual 1007.9845.32 ─ 15
When loading an instrument setting, it is possible to select whether the current frequency
and level setting is to be retained or whether the stored settings are to be activated. It is
possible to delete stored instrument settings. A file can be copied by loading it with
"Recall" and then storing it under a new name.
Settings can be transferred easily between instruments with different equipment options
and/or firmware versions because only the settings which differ from the preset values
are affected. When settings are loaded, only those which are possible on the instrument
are implemented. Error messages indicate the settings which cannot be implemented.
The stored file is transferred from one instrument to another using the memory stick or
by means of a network drive.
General file management functions such as copying and moving data are available in the
"File Manager" dialog.
5.2.8.1 File Menu
The settings available in the File menu "Save/Recall" depend on the operation selected
under "Select Operation".
For more information, see chapter 4.7.1, "File Select Dialog", on page 115.
Select Operation
Selects the file function.
"Save…"
Calls the menu for storing the current instrument setting (see chap-
ter 5.2.8.2, "Storing Instrument Settings", on page 157).
"Recall..."
Calls the menu for calling up a stored instrument setting (see chap-
ter 5.2.8.3, "Loading Instrument Settings", on page 159).
5.2.8.2 Storing Instrument Settings
If "Save" is selected under "Select Operation", the File menu provides options for storing
the current instrument setting in a file.
General Instrument Settings
To Next Page
Loading...
