Rohde & Schwarz SMU200A - Graphical Display - Graphics

Instrument Function
R&S
®
SMU200A
162Operating Manual 1007.9845.32 ─ 15
Rename
Renames the selected file or directory. The new name can be entered in the "New File-
name" dialog.
SCPI command:
:MMEMory:MOVE on page 550
Delete
Deletes the selected file. Before the file is deleted, a message appears prompting the
user to confirm deletion of the file.
SCPI command:
:MMEMory:DELete on page 549
Create New Directory
Creates a new directory. The name of the new directory can be entered in the "New
Directory" dialog.
Note: When the subdirectory is entered, it is possible to enter an absolute path name
(e.g. D:/USER/MEAS) or the path relative to the current directory (e.g. ../MEAS).
The directory is created as a subdirectory in the selected level.
SCPI command:
:MMEMory:MDIRectory on page 550
5.3 Graphical Display - Graphics
The R&S Signal Generator can be used to graphically display the generated baseband
signal. A selection of different signal displays assists the user in assessing and checking
the increasingly complex modulation signals.
Most graphical displays are possible both for internally generated and externally applied
baseband signals.
The Graphics function block is available for instruments with the option:
●
R&S SMU-B13 (Baseband Main Module) and one of the options R&S SMU-B9/B10/
B11 (UniCod + ARB)
●
R&S SMU-B17 (Baseband input)
●
R&S SMU-B62 (Noise Generator)
It is the baseband signal actually generated that is recorded and displayed, and not a
signal calculated on the basis of the set parameters.
This graphical display allows the user to quickly view and check the current signal char-
acteristics and also gives an overview of the changes in the signal over time. The signal
quality can be permanently monitored. The results of parameter changes on the signal,
Graphical Display - Graphics