Rohde & Schwarz SMU200A - [:Source<Hw>]:Bbin:srate:fifo[:Status]; [:Source<Hw>]:Bbin:srate:source; [:Source]:Bbin:state

Remote Control Commands
R&S
®
SMU200A
697Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BBIN:SRATe:FIFO[:STATus]?
This command indicates the state of the signal transmission.
Return values:
OK|OFLow|URUN
OK
Resampling is working properly.
OFL = Overflow
The external sample rate frequency is too high which causes an
overflow in signal transmission.
URUN = Underrun
The external sample rate frequency is too low which causes an
underrun in signal transmission.
<Status>
BBIN:SRAT:FIFO:STAT
queries the FIFO Status of the sample rate.
Example:
Query onlyUsage:
[:SOURce<hw>]:BBIN:SRATe:SOURce <Source>
This command queries the source for estimating the sample rate of the digital input signal
or defining it by the user.
Note: With a connected R&S EX-IQ-Box either the internal clock source (User defined)
or an external clock (Digital I/Q In) can be selected in the settings dialog of the R&S EX-
IQ-Box. Therefore, the sample rate source is only indicated in this field.
Parameters:
USER|DIN
USER
<Source>
*RST:
BBIN:SRAT:SOUR
queries the sample rate mode of the external digital baseband
signal.
Example:
[:SOURce]:BBIN:STATe <State>
This command switches the feeding of an external analog signal into the signal path on/
off.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
SOURce Subsystem