Rohde & Schwarz SMU200A - Working with Units

Manual Operation
R&S
®
SMU200A
102Operating Manual 1007.9845.32 ─ 15
4.4.5 Working with Units
The unit of a parameter is displayed next to the value. When the parameter is edited, the
unit is selected either from the list or by means of the front-panel keys. When the entry
is completed, the unit can be changed. In this case the value remains unchanged but is
automatically adapted to the new unit.
While operating the instrument by means of a mouse, assign the unit to the selected
parameter before entering its value.
Assigning a unit
To assign a unit to a value, use one of the following alternatives:
1. Press a UNIT key on the front panel.
2. Select a "Unit" in the selection field next to the parameter value.
Press the ENTER key.
The unit displayed in the entry field next to the value is assigned.
Changing a unit
To subsequently change a unit, i.e. after the entry has been terminated and when the
editing mode is not active, use one of the following alternatives:
1. Press a UNIT key on the front panel.
2. Select"Unit" in the selection field next to the parameter value.
The value remains unchanged but the display is automatically adapted to the new
unit, i.e. the value is recalculated to suit the new unit.
The new unit is indicated in the value field of the menu.
4.4.6 Selecting a Value from a List
Selection lists provide a list of predefined values for the selected parameter.
To select a item from a list, proceed as follow:
1. Press ENTER key to open the list.
2. Use one of the following alternatives to navigate through the list:
Setting Parameters