Rohde & Schwarz SMU200A - Diagnostic Subsystem

Remote Control Commands
R&S
®
SMU200A
527Operating Manual 1007.9845.32 ─ 15
Parameters:
NEGative|POSitive
POSitive
<Slope>
*RST:
CLOC:INP:SLOP NEG
The active slope of the external clock signal at the CLOCK con-
nector is the falling slope.
Example:
:CLOCk:OUTPut:MODE <Mode>
The command sets the output of bit or symbol clock pulses at the CLOCK OUT connector
at the rear panel.
Parameters:
SYMBol|BIT
SYMBol
<Mode>
*RST:
CLOC:OUTP:MODE SYMB
The internal symbol clock is output at the CLOCK OUT connector.
Example:
:CLOCk:OUTPut:SOURce? <Source>
The command queries the path for which the clock signal at the CLOCK OUT connector
is to be output.
Return values:
A
A
<Source>
*RST:
CLOC:OUTP:SOUR
queries the path for which the clock signal at the CLOCK OUT
connector is to be output.
Response: A
The clock signal of path is output at the CLOCK OUT connector.
Example:
Query onlyUsage:
7.7 DIAGnostic Subsystem
The DIAGnostic system contains the commands used for instrument diagnosis and
servicing. SCPI does not define any DIAGnostic commands; the commands listed here
are all Device-specific. All DIAGnostic commands are query commands which are not
influenced by *RST.
:DIAGnostic<hw>:BGINfo................................................................................................528
:DIAGnostic<hw>:BGINfo:CATalog..................................................................................528
:DIAGnostic:INFO:OTIMe................................................................................................529
DIAGnostic Subsystem