Rohde & Schwarz SMU200A - Filling the Correction List Automatically

Instrument Function
R&S
®
SMU200A
229Operating Manual 1007.9845.32 ─ 15
Destination / Source - User Correction
Calls the "File Manager" for selecting the user correction list to be exported (source) into
an ASCII file or the destination for the ASCII file to be imported (destination) in.
SCPI command:
[:SOURce<hw>]:CORRection:DEXChange:SELect on page 706
Import / Export - User Correction
Starts the export or import of the selected file.
When import is selected, the ASCII file is imported as user correction list.
When export is selected, the user correction list is exported into the selected ASCII file.
SCPI command:
[:SOURce<hw>]:CORRection:DEXChange:EXECute on page 705
5.5.9.2 Filling the Correction List automatically
The "Fill Table" menu enables you to automatically set the level correction values.
The start line and the number of rows to be filled are defined under "From" and "Range."
The column to be filled is selected under "Select column to fill". Depending on the selec-
tion here, the default for start, end, and increment value are set. As the settings are
interdependent, a change of one parameter may result in the automatic change of one
or more of the other parameters. The filling of the column with the selected value settings
is started with button "Fill".
The correction list entries are only computed when the "Fill" button is pressed.
From
Sets the start value of the index range.
SCPI command:
n.a.
RF Signal and Analog Modulations - RF Block