Rohde & Schwarz SMU200A - Page 726

Remote Control Commands
R&S
®
SMU200A
706Operating Manual 1007.9845.32 ─ 15
CORR:DEXC:MODE IMP
selects that ASCII files with frequency and level value pairs are
imported and transferred into user correction lists.
CORR:DEXC:AFIL:SEL 'D:
/user/ucor/import/ucor.csv'
selects that ASCII file ucor.csv is imported.
CORR:DEXC:SEL 'D:/user/ucor/import/ucor_imp'
selects that the ASCII file ucor.csv is imported into user correction
list ucor_imp.
Example:
[:SOURce<hw>]:CORRection:DEXChange:SELect <Select>
The command selects the user correction list to be imported or exported.
The user correction files are stored with the fixed file extensions *.uco in a directory of
the user's choice. The directory applicable to the commands is defined with the command
MMEMory:CDIR. A path can also be specified in command SOUR:CORR:DEXC:SEL, in
which case the files are stored or loaded in the specified directory.
Parameters:
<list name><Select>
CORR:DEXC:MODE IMP
selects that ASCII files with frequency and level value pairs are
imported and transferred into user correction lists.
CORR:DEXC:AFIL:SEL 'D:
/user/ucor/import/ucor.csv'
selects that ASCII file ucor.csv is imported.
CORR:DEXC:SEL 'D:/user/ucor/import/ucor_imp'
selects that the ASCII file ucor.csv is imported into user correction
list ucor_imp.
Example:
[:SOURce<hw>]:CORRection:CSET[:SELect] <Select>
The command selects the table for user correction. Level correction must also be acti-
vated with the command SOURce<[1]|2>:CORRection:CSET:STATe ON.
The lists are stored with the fixed file extensions *.uco in a directory of the user's choice.
The directory applicable to the commands is defined with the command
MMEMory:CDIR. A path can also be specified in command :SOUR:CORR:CSET:SEL, in
which case the files in the specified directory are selected.
Parameters:
<table name><Select>
CORR:CSET 'D:/Lists/ucor/ucor1'
selects the table ucor1 for RF output A.
CORR ON
activates level correction for RF output A. Correction is performed
using the table ucor1.
Example:
SOURce Subsystem