Rohde & Schwarz SMU200A - Hardcopy Dialog

Instrument Function
R&S
®
SMU200A
151Operating Manual 1007.9845.32 ─ 15
5.2.5.1 Hardcopy Dialog
Destination
Selects if the hardcopy is printed or stored in a file (see also "Printer Options"
on page 152 or "File Options" on page 153).
SCPI command:
:HCOPy:DEVice on page 533
Options
Opens the Hardcopy Options dialog for configuring the hardcopy. Depending on the
selected destination either the printer or the file parameters can be set (see also "Printer
Options" on page 152 or "File Options" on page 153).
SCPI command:
n.a.
Printer
If device printer is selected some settings are already offered in the hardcopy dialog. All
configuration parameters are available in "Printer Options" on page 152.
File
Some configuration parameters are already offered in the Hardcopy dialog. All configu-
ration parameters are available in "File Options" on page 153.
Automatic Naming
Activates, deactivates automatic generation of the file name. Automatic naming is con-
figured in the "Options…" submenu, see "File Options" on page 153.
File Info
Indicates the file name. The file name can be entered either manually via the file manager
(button "File…") or generated automatically (Automatic naming checkbox). Automatic
naming is configured in the "Options…" submenu.
SCPI command:
:HCOPy:FILE[:NAME] on page 534
:HCOPy:FILE[:NAME]:AUTO:STATe on page 538
:HCOPy:FILE[:NAME]:AUTO:FILE on page 535
General Instrument Settings