Instrument Function
R&S
®
SMU200A
133Operating Manual 1007.9845.32 ─ 15
On/Off GUI Update
Switchs on/off update of the displayed parameters.
Switching off the update of the displayed parameters increases the speed for certain
settings.
Note: It is especially recommended to switch off the GUI update for optimum sweep
performance with short dwell times and for fast settling times.
SCPI command:
:SYSTem:DISPlay:UPDate on page 791
5.2.3.5 Install SW-Option
Newly purchased software options are enabled in the "Install SW-Options" menu. They
are ready to operate after they are enabled by means of a key code supplied with the
option.
Only if the R&S Signal Generator is equipped with an older firmware version, a firmware
update prior to enabling the software option may be required. The information on the valid
firmware versions for the purchased software option is provided together with the option.
The firmware update is described in the service manual instrument, chapter 4 (on CD
ROM, supplied with the instrument).
5.2.3.6 NRP-Z Info/Update
In the "NRP-Z Info/Update…" dialog, the connected power sensors are indicated together
with their serial number, revision state and features. The software of an connected sensor
can be updated to a newer version.
To access the "NRP-Z Info/Update…" dialog, select "System" and press the SETUP or
MENU key.
General Instrument Settings
To Next Page
Loading...
