Instrument Function
R&S
®
SMU200A
146Operating Manual 1007.9845.32 ─ 15
Parameter
Negotiation Auto Detect
VXI-11 Discovery Enabled
The LAN settings are configured using the instrument's LXI Browser Interface described
in chapter 2.9, "LXI Configuration", on page 58.
To open the "Instrument Home Page" (welcome page), type the instrument's computer
name (host name) or IP address in the address field of the browser on your PC, e.g.
http://10.111.10.175.
Note: Do not add the missing zeros in the IP address, while opening the Instrument Home
Page.
SCPI command:
n.a.
5.2.3.15 Protection
The "Protection" menu provides access to the unlocking of protected service functions
(authorized personnel of R&S Service Departments only). To deactivate the protection,
the correct password has to be entered. After the instrument has been switched on, the
protection levels 1 to 5 are automatically activated.
Protection Level/Password
Protection Level 1 can be activated to expand the functionality of the internal adjustment
and the access the selftests.
The password is 123456.
SCPI command:
:SYSTem:PROTect<ch>[:STATe] on page 794
5.2.3.16 Security
The "Security" dialog provides access to the passwords and mass storage security set-
tings. To open this menu, use the SETUP or MENU key under "Protection".
The menu is divided into the password sections and the security settings section. In the
password section, the passwords for securing a controlled access to the instrument are
defined and changed.
General Instrument Settings
To Next Page
Loading...
