Rohde & Schwarz SMU200A - COMMENT: String; COPYRIGHT: String; DATA BITLENGTH: Bitlength

Remote Control Commands
R&S
®
SMU200A
499Operating Manual 1007.9845.32 ─ 15
{CLOCK: 54000000}
BB:ARB:WAV:TAG? 'CLOCK'
queries the content of the CLOCK tag.
Response: 54000000
the clock frequency is set to 54 MHz.
Example:
Setting onlyUsage:
{COMMENT: string}
The tag contains a plain text ASCII string of arbitrary length. The string is not analyzed
in the R&S SMU. It is used to describe the file. The string is allowed to contain all printable
ASCII characters except the closing curly bracket.
{COMMENT: File with data for 3GPP enhanced
channels}
BB:ARB:WAV:TAG? 'COMMENT'
queries the content of the COMMENT tag of the selected waveform
file.
Response: 'File with data for 3GPP enhanced
channels'
the comment on the waveform reads "File with data for 3GPP
enhanced channels".
Example:
Setting onlyUsage:
{COPYRIGHT: string}
The tag contains an ASCII string of arbitrary length. The string is not analyzed in the R&S
SMU. It is used to store copyright information about the file content.
{COPYRIGHT: Rohde&Schwarz}
BB:ARB:WAV:TAG? 'COPYRIGHT'
queries the content of the COPYRIGHT tag of the selected wave-
form file.
Response: 'Rohde&Schwarz'
copyright resides with Rohde&Schwarz.
Example:
Setting onlyUsage:
{DATA BITLENGTH: BitLength}
(mandatory for data lists)
The tag contains the length of the data held in the DATA LIST tag in bits in ASCII format.
R&S Signal Generator Waveform and List Format