Rohde & Schwarz SMU200A - [:Source<Hw>]:Bb:arb:wsegment:cload; [:Source<Hw>]:Bb:arb:wsegment

Remote Control Commands
R&S
®
SMU200A
615Operating Manual 1007.9845.32 ─ 15
Section chapter 7.3, "R&S Signal Generator Waveform and List Format", on page 496
describes the ARB waveform format and how it is used to transmit waveforms via the IEC
bus.
[:SOURce<hw>]:BB:ARB:WSEGment..............................................................................615
[:SOURce<hw>]:BB:ARB:WSEGment:CLOad...................................................................615
[:SOURce<hw>]:BB:ARB:WSEGment:CONFigure:OFILe...................................................616
[:SOURce<hw>]:BB:ARB:WSEGment:CONFigure:SEGMent:APPend.................................616
[:SOURce<hw>]:BB:ARB:WSEGment:CONFigure:SEGMent:CATalog................................617
[:SOURce<hw>]:BB:ARB:WSEGment:CREate..................................................................617
[:SOURce<hw>]:BB:ARB:WSEGment:NAME....................................................................618
[:SOURce<hw>]:BB:ARB:WSEGment:NEXT.....................................................................618
[:SOURce<hw>]:BB:ARB:WSEGment:NEXT:EXECute......................................................619
[:SOURce<hw>]:BB:ARB:WSEGment:NEXT:SOURce.......................................................619
[:SOURce<hw>]:BB:ARB:WSEGment:SEQuence:APPend.................................................619
[:SOURce<hw>]:BB:ARB:WSEGment:SEQuence:SELect..................................................620
[:SOURce<hw>]:BB:ARB:WSEGment?
This command queries the currently output segment of the multi segment waveform.
Return values:
float<Wsegment>
BB:ARB:WSEG?
queries the currently output segment.
Response 2
segment 2 is currently output.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:ARB:WSEGment:CLOad <Cload>
This command creates a multi segment waveform using the current entries of the speci-
fied configuration file.
This multi segment waveform is saved with the file name specified in the configuration
file . The file extension is *.wv. Digital standard "ARB" is activated, the new multi segment
waveform is loaded and the first segment is output in accordance to the trigger settings.
Setting parameters:
string<Cload>
SOURce Subsystem