Rohde & Schwarz SMU200A - Software; Options

Instrument Function
R&S
®
SMU200A
131Operating Manual 1007.9845.32 ─ 15
Power On Count
Displays the number of power-on.
SCPI command:
:DIAGnostic:INFO:POCount on page 529
Assembly
The tables list the installed assemblies.
"Path"
Shows the path to which the assembly belongs.
"Assembly"
Assembly name
"Part Number"
Part Number of assembly
"Serial Number"
Serial Number of assembly
"Revision"
Revision state of assembly
"Slot"
Indicates whether the assembly is connected to the serial bus or PCI bus.
SCPI command:
:DIAGnostic<hw>:BGINfo on page 528
5.2.3.3 Software / Options
The "Software/Options" dialog shows the firmware version of the instrument software as
well as all installed hardware and software options.
Software options purchased at a later stage can be activated with a keycode. The acti-
vation code is supplied with the software option. How to install options is described in
Chapter 4 of the Service Manual (supplied with the instrument).
The installation of hardware options purchased at a later stage is also described in Chap-
ter 4 of the Service Manual (supplied with the instrument). Most hardware options need
to be installed at an authorized Rohde&Schwarz service shop.
To access the "Software/Options" dialog, select "System" and press the SETUP or
MENU key.
The menu is devided into the following sections:
●
"Firmware"
●
"Hardware Options"
●
"Software Options"
●
"WinIQSIM"
●
"Loaded Modules"
General Instrument Settings