Rohde & Schwarz SMU200A - [:Source<Hw>]:Bb:arb:wsegment:name; [:Source<Hw>]:Bb:arb:wsegment:next

Remote Control Commands
R&S
®
SMU200A
618Operating Manual 1007.9845.32 ─ 15
MMEM:CDIR 'D:/user/waveform'
sets the default directory to D:/user/waveform.
BB:ARB:WSEG:CONF:SEL 'new'
creates the configuration file new.inf_mswv in the default direc-
tory.
BB:ARB:WSEG:CONF:SEGM:APP 'arb1.wv'
'includes waveform arb1.wv as segment 1 in the configuration
file. The waveform must be available in the default directory.
BB:ARB:WSEG:CONF:OFIL 'multi_wv1'
defines the file name multi_wv1.wv for the multi segment wave-
form.
BB:ARB:WSEG:CRE 'new'
creates multi segment waveform multi_wv1.wv using the set-
tings of the configuration file new.inf_mswv.
Example:
Setting onlyUsage:
[:SOURce<hw>]:BB:ARB:WSEGment:NAME?
This command queries the name of the waveform of the currently output segment of the
multi segment waveform.
Return values:
string<Name>
BB:ARB:WSEG:NAME?
queries the currently output segment.
Example:
Query onlyUsage:
[:SOURce<hw>]:BB:ARB:WSEGment:NEXT <Next>
This command selects the segment to be output.
Parameters:
float
0 to 2000
1
<Next>
Range:
*RST:
SOURce Subsystem