Remote Control Commands
R&S
®
SMU200A
761Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:PHASe:REFerence
The command adopts the phase set with SOURce:PHASe:ADJust as the current phase.
PHAS 0.1RAD
changes the phase by 0.1 RAD relative to the current phase.
PHAS:REF
adopts the set phase as the current phase.
Example:
Event
SCPI conform
Usage:
7.15.16 SOURce:PM Subsystem
The PM subsystem contains the commands for checking the phase modulation. The
settings for the internal modulation source (LF generator) are made in the
SOURce:LFOutput subsystem.
For information about the requred options, see chapter 5.5.11.5, "Phase Modulation
(PhiM)", on page 241.
[:SOURce<hw>]:PM[:DEViation]......................................................................................761
[:SOURce<hw>]:PM:EXTernal:COUPling.........................................................................762
[:SOURce<hw>]:PM:MODE............................................................................................762
[:SOURce<hw>]:PM:SENSitivity......................................................................................763
[:SOURce<hw>]:PM:SOURce.........................................................................................763
[:SOURce<hw>]:PM:STATe............................................................................................763
[:SOURce<hw>]:PM[:DEViation] <Deviation>
The command sets the modulation deviation of the phase modulation in RAD. The max-
imal deviation depends on the RF frequency set and the selected modulation mode (see
data sheet).
Parameters:
float
0 to 20
See data sheet
1
RAD
<Deviation>
Range:
Increment:
*RST:
Default unit:
PM 5
sets the PM modulation deviation to 5 RAD
Example:
SCPI conformUsage:
SOURce Subsystem
To Next Page
Loading...
