Remote Control Commands
R&S
®
SMU200A
583Operating Manual 1007.9845.32 ─ 15
BB:ARB:CLOC:MODE SAMP
selects clock type "Sample", i.e. the supplied clock is a sample
clock.
Example:
[:SOURce<hw>]:BB:ARB:CLOCk:MULTiplier <Multiplier>
The command specifies the multiplier for clock type "Multiple Samples"
(:BB:ARB:CLOCk:MODE MSAM) in the case of an external clock source.
For two-path instruments, the only numerical suffix allowed for SOURce is 1, since the
external clock source is permanently allocated to path A.
Parameters:
float
1 to 64
1
4
<Multiplier>
Range:
Increment:
*RST:
BB:ARB:CLOC:SOUR EXT
selects the external clock source. The clock is supplied via the
CLOCK connector.
BB:ARB:CLOC:MODE MSAM
selects clock type Multiple Samples, i.e. the supplied clock has a
rate which is a multiple of the sample rate.
BB:ARB:CLOC:MULT 12
The multiplier for the external clock rate is 12.
Example:
[:SOURce<hw>]:BB:ARB:CLOCk:SOURce <Source>
The command selects the source for the digital modulation clock.
Parameters:
INTernal|EXTernal|AINTernal
INTernal
The internal clock reference is used.
EXTernal
The external clock reference is supplied to the CLOCK connector.
INTernal
<Source>
*RST:
BB:ARB:CLOC:SOUR EXT
selects an external clock reference. The clock is supplied via the
CLOCK connector.
BB:ARB:CLOC:MODE SAMP
enters clock type sample.
Example:
Trigger Settings
[:SOURce<hw>]:BB:ARB:TRIGger:ARM:EXECute............................................................584
SOURce Subsystem
To Next Page
Loading...
