Rohde & Schwarz SMU200A - Generating a Hard Copy of the Display

Instrument Function
R&S
®
SMU200A
150Operating Manual 1007.9845.32 ─ 15
The status message additionally indicates whether the LOCAL key is disabled or enabled
(see also chapter 6.2.1, "Switching to Remote Control", on page 455).
If the "REMOTE" status message is shown, the LOCAL key switches the instrument from
remote control to manual control. The current command must be fully processed before
the mode is switched, otherwise the instrument switches immediately back to remote
control.
If the "REM-LLO" status message is displayed, the instrument can be switched from
remote control to manual control by means of remote control only (e.g. with the Visual
Basic command CALL IBLOC (generator%)); the LOCAL key is disabled. The key is
disabled by remote control with the command LLO.
When switching from remote to manual control, the display update suppression function,
if active ("SETUP > GUI Update" is Off), is automatically deactivated ("SETUP > GUI
Update" is On).
5.2.5 Generating a Hard Copy of the Display
The "HCOPY" key opens a window for configuring the hardcopy setting, like output file
format, printer or path and file name. The parameters to be set change in dependency of
the selected output device.
General Instrument Settings