Rohde & Schwarz SMU200A - Source:bb:mccw Subsystem

Remote Control Commands
R&S
®
SMU200A
667Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:IMPairment:QUADrature[:ANGLe] <Angle>
This command sets the quadrature offset for the digital I/Q signal.
Parameters:
float
-10 to 10
0.02
0
DEG
<Angle>
Range:
Increment:
*RST:
Default unit:
BB:IMP:QUAD:ANGL -5DEG
sets the quadrature offset to -5 degrees.
Example:
[:SOURce<hw>]:BB:IMPairment:STATe <State>
The command activates (ON) and deactivates (OFF) the three impairment or correction
values LEAKage, QUADrature and IQRatio for the digital baseband signal prior to input
into the I/Q modulator.
Parameters:
0|1|OFF|ON
OFF
<State>
*RST:
BB:IMP:STAT OFF
deactivates digital impairment.
Example:
7.15.3.6 SOURce:BB:MCCW Subsystem
This subsystem contains the commands for setting the Multi Carrier CW signals.
General Settings and Carrier Setup Settings
[:SOURce<hw>]:BB:MCCW:STATe.................................................................................668
[:SOURce<hw>]:BB:MCCW:PRESet................................................................................668
[:SOURce<hw>]:BB:MCCW:CARRier:COUNt...................................................................668
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe...........................................................669
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer...........................................................669
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:STATe............................................................670
[:SOURce<hw>]:BB:MCCW:CARRier:PHASe...................................................................671
[:SOURce<hw>]:BB:MCCW:CARRier:POWer...................................................................671
[:SOURce<hw>]:BB:MCCW:CARRier:SPACing.................................................................672
[:SOURce<hw>]:BB:MCCW:CARRier:STATe....................................................................672
[:SOURce<hw>]:BB:MCCW:CFACtor...............................................................................672
[:SOURce<hw>]:BB:MCCW:CFACtor:MODE....................................................................673
[:SOURce<hw>]:BB:MCCW:CLOCk.................................................................................673
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:EXECute........................................................674
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe:STEP.................................................674
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe[:STARt]...............................................675
SOURce Subsystem