Remote Control Commands
R&S
®
SMU200A
669Operating Manual 1007.9845.32 ─ 15
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe <Phase#0>[,<Phase#1>,...]
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:PHASe? [start[,count]]
The command sets the start phase of the carrier with the aid of a value list. The first value
in the list is assigned to the carrier with index 0, the second value to the carrier with index
1, etc. The maximum length corresponds to the maximum number of multi carriers. There
is no need to enter all the values every time. Values not set by the value list are set with
the default values provided they have already been explicitly set by a previous command.
If this is the case, the values continue to apply until overwritten.
Setting parameters:
string
0 to 360
0.01
0
DEG
Query parameters:
string
If the query is expanded by using the two parameters <start> and
<count>, the value list is read out in smaller sections. Start is
expressed in position of bit, count in number of values. Without the
parameters all values are always read out starting from the first
value.
<Phase#0>[,<Phase#
1>,...]
Range:
Increment:
*RST:
Default unit:
[start[,count]]
BB:MCCW:CARR:LIST:PHAS 90 DEG, 90 DEG, 90 DEG,
80 DEG
sets a start phase for carriers 0, 1, 2 and 3.
BB:MCCW:CARR:LIST:PHAS 2,3
queries the phase of carrier 1, 2 and 3.
Response: 90,90,80
Example:
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer <Power#0>[,<Power#1>,...]
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:POWer? [start[,count]]
The command sets the power of the carrier with the aid of a value list. The first value in
the list is assigned to the carrier with index 0, the second value to the carrier with index
1, etc. The maximum length corresponds to the maximum number of multi carriers. There
is no need to enter all the values every time. Values not set by the value list are set with
the default values provided they have already been explicitly set by a previous command.
If this is the case, the values continue to apply until overwritten.
SOURce Subsystem
To Next Page
Loading...
