Rohde & Schwarz SMU200A - Page 690

Remote Control Commands
R&S
®
SMU200A
670Operating Manual 1007.9845.32 ─ 15
Parameters:
string
-80 dB to 0 dB
0.01 dB
0 dB
Query parameters:
string
If the query is expanded by using the two parameters <start> and
<count>, the value list is read out in smaller sections. Start is
expressed in position of bit, count in number of values. Without the
parameters all values are always read out starting from the first
value.
<Power#0>[,<Power#
1>,...]
Range:
Increment:
*RST:
[start[,count]]
BB:MCCW:CARR:LIST:POW -65 dB, -30 dB, -50
dB,...
sets the power of carrier 0 to -65 dB, carrier 1 to -30 dB and so on.
BB:MCCW:CARR:LIST:POW 2,2
queries the power of carrier 1 and 2.
Response: -30,-50
Example:
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:STATe <State#0>[,<State#1>,...]
[:SOURce<hw>]:BB:MCCW:CARRier:LIST:STATe? [start[,count]]
The command switches the carrier on or off with the aid of a value list. The first value in
the list is assigned to the carrier with index 0, the second value to the carrier with index
1, etc. The maximum length corresponds to the maximum number of multi carriers. There
is no need to enter all the values every time. Values not set by the value list are set with
the default values provided they have already been explicitly set by a previous command.
If this is the case, the values continue to apply until overwritten.
Parameters:
ON|OFF[,ON|OFF,...]
ON
Query parameters:
string
If the query is expanded by using the two parameters <start> and
<count>, the value list is read out in smaller sections. Start is
expressed in position of bit, count in number of values. Without the
parameters all values are always read out starting from the first
value.
<State#0>[,<State#1>
,...]
*RST:
[start[,count]]
BB:MCCW:CARR:LIST:STAT ON, OFF, ON,....
switches carrier 0 on, carrier 1 off, etc.
BB:MCCW:CARR:LIST:POW 2,2
queries the states of carrier 1 and 2.
Response: 0,1
Example:
SOURce Subsystem