Preparing for Use
R&S
®
SMU200A
20Operating Manual 1007.9845.32 ─ 15
2.1.1 Utility Keys
The keys to the left of the display cause the R&S SMU to return to a definite instrument
state and provide information on the instrument and assistance.
For more information refer to chapter "Instrument Settings".
PRESET
Sets the instrument to a defined state (see chapter 2.3.4.4, "Default Settings",
on page 36).
LOCAL
Switches from remote control to local (manual) control.
SETUP
Opens the "Setup" dialog for configuring presettings.
For more information, see chapter 5.2.3, "General Configuration of Instrument - Setup
Key", on page 127.
HCOPY
Opens the "Hardcopy" menu for configuring and starting printing.
For more information, see chapter 5.2.5, "Generating a Hard Copy of the Display",
on page 150.
INFO
Displays status messages, error messages and warnings.
HELP
Displays context-sensitive help text.
2.1.2 Standby LEDs and Standby Key
The standby LEDs and the ON/STANDBY key are located in the bottom left corner of the
front panel.
The ON/STANDBY key toggles the instrument between standby and ready state (indi-
cated by the standby LEDs).
The standby LEDs indicate the instrument states as follow:
●
the green LED (left) is on when the instrument is ready for operation,
●
the yellow LED (right) is on in the standby mode.
Front Panel Tour
To Next Page
Loading...
