Rohde & Schwarz SMU200A - General Configuration of Instrument - Setup Key

Instrument Function
R&S
®
SMU200A
127Operating Manual 1007.9845.32 ─ 15
●
"Modulations State" = Off
●
Uninterrupted level setting are switch off
"Level Attenuator Mode" = AUTO
●
Internal level control "Level ALC" = AUTO
●
User correction "Level Ucor" = OFF
●
"LF output State" = Off
●
"Sweep State" = Off
●
"List mode State" = Off
Settings that are not affected by the PRESET key
●
Reference frequency settings ("Ref Oscillator" menu)
●
Power on settings ("Level/EMF" menu)
●
Network settings ("Setup" menu)
●
GPIB address ("Setup" menu)
●
Password and settings protected by passwords ("Setup" menu)
●
Start/Stop Gui Update ("Setup" menu)
●
Display and keyboard settings ("Setup" menu)
Note: In remote control it is possible to preset the settings of the two instrument path
separately (see chapter 7.2, "Preset Commands", on page 494).
Resetting the instrument to the factory state is possible in the Factory Preset dialog.
SCPI command:
*RST on page 492
5.2.3 General Configuration of Instrument - Setup Key
The SETUP key opens the "Setup" dialog.
The "Setup" dialog is divided into several sections.
●
The "System" section is used to set general instrument parameters.
●
The "Test" section is used to perform function tests.
●
The "Environment" section is used to configure the controller interfaces.
●
The "Remote" section is used to configure the remote control interfaces.
●
The "Protection" is used to set the protection level for service functions.
●
The "Settings" section contains the "Save/Recall" dialog.
Most submenus of this key can be accessed only via the SETUP key or the menu tree
( MENU key), with the following exceptions:
●
The "Reference Oscillator" dialog can also be called up in the "RF" block and is
therefore described in the section on this block (see chapter 5.5.4, "Reference Oscil-
lator", on page 204).
●
The "Save/Recall" dialog can also be called up with the FILE key and is therefore
described in the section on this key (see chapter 5.2.8, "Storing and Loading Instru-
ment Data - File Key", on page 156.
●
The "Global Trigger/Clock/ External Inputs" dialog is also available in all modulation
menus of the "Baseband" function block where it can be called up with the "Global
Trigger/Clock Settings" button in the corresponding "Trigger/Marker/Clock" dialog.
General Instrument Settings