Manual Operation
R&S
®
SMU200A
97Operating Manual 1007.9845.32 ─ 15
An alternatively way to access a dialog is to use the Winbar buttons or front-panel softkeys
or to use the HIDE (CTRl+H), CLOSE (ESC), DIAGRAM (CTRL+D) and REARR (CTRL
+A) keys on the front panel.
For a quick access to the dialogs, use one of the following alternative methods.
Displaying the block diagram or a dialog in the foreground
1. Press the DIAGRAM (CTRL+D) key to move the cursor to the block diagram.
All active menus are minimized and displayed in the form of Winbar buttons.
2. Press the associated softkey (CTRL+F1 .. F8) to display the dialog in the foreground
again.
Accessing the menu tree
► Press the MENU (CTRL+M) key to open the complete menu tree
Calling the File, Setup or Hardcopy menus
► Use the FILE (CTRL+S), SETUP (CTRL+E) or HCOPY (CTRL+Y) keys to open the
respective menus.
Minimizing an active menu
► Use the HIDE (CTRL+H) key to minimize an active menu.
It is displayed in the form of a Winbar button.
Automatically arranging displayed menus
► Press the REARR (CTRL+A) key to rearrange all open menus so that they overlap
as little as possible.
Activating the Windbar
► Use the WINBAR (CTRL+W) key to toggle the cursor between a button of the "Win-
bar" and the block diagram.
The button that was active last in the Winbar is highlighted.
Closing an active menu
► Press the CLOSE key to close an active menu.
Tip: If the cursor is at the highest menu level, you can also use the ESC key to close
the active menu.
Accessing the header area
► Press the FREQ (CTRL+F) and LEVEL (CTRL+L) keys to activate the "Frequency"
or "Level" entry fields in the header area.
Accessing Dialogs
To Next Page
Loading...
