Instrument Function
R&S
®
SMU200A
167Operating Manual 1007.9845.32 ─ 15
Clicking the button again hides the reference curves.
The reference curves must be defined beforehand using the "Copy to Ref" button.
SCPI command:
n.a.
Copy to ref
Defines the current curve as the reference curve.
A window opens in which the curve can be given a comment and a color.
First of all the desired color is highlighted in the top window. If this color has already been
assigned to a reference curve, this curve is overwritten. The command is entered in the
bottom "Comment" section. This comment then appears next to the highlighted color.
Up to 5 reference curves can be defined and displayed simultaneously in different colors
together with the current signal.
Each reference curve is available until it is deleted.
"Display area"
The comments entered for the defined reference curve are shown in the
display area next the assigned color. A maximum of five colors (and ref-
erence curves) are available. If no reference curve is assigned to a par-
ticular color, the comment <empty> is displayed.
"Comment"
Enters a comment for the current curve which is to be defined as the
reference curve. This comment then appears next to the highlighted color
in the display area.
Graphical Display - Graphics
To Next Page
Loading...
