Instrument Function
R&S
®
SMU200A
370Operating Manual 1007.9845.32 ─ 15
The "Trigger In" section is where the trigger for the modulation signal is set. Various
parameters will be provided for the settings, depending on which trigger source - internal
or external - is selected. The current status of signal generation ("Running" or "Stop-
ped") is indicated for all trigger modes.
The "Marker Mode" section is where the marker signals at the MARKER output connec-
tors are configured.
The "Marker Delay" section is where a marker signal delay can be defined, either without
restriction or restricted to the dynamic section, i.e., the section in which it is possible to
make settings without restarting signal and marker generation.
The "Clock Settings" section is where the clock source is selected and - in the case of an
external source - the clock type.
The "Global Trigger/Clock Settings" button leads to a submenu for general trigger, clock
and external input settings.
Baseband Signal - Baseband Block
To Next Page
Loading...
