Remote Control Commands
R&S
®
SMU200A
580Operating Manual 1007.9845.32 ─ 15
Parameters:
float
0.1 dB
0 dB
<Pgain>
Increment:
*RST:
BB:PGA 3dB
sets a relative path gain of 3 dB for the baseband signal of path A
compared to the baseband signal of path B.
Example:
[:SOURce<hw>]:BB:POFFset <Poffset>
The command sets the relative phase offset for the selected baseband signal compared
to the baseband signals of the other baseband sources (second path or external base-
band).
The phase offset affects the signal on the "baseband block" output.
Parameters:
float
0 to 359.9
0.1 DEG
0 DEG
<Poffset>
Range:
Increment:
*RST:
BB:POFF 0.5DEG
sets a relative phase offset of 0.5 DEG for the baseband signal
Example:
[:SOURce<hw>]:BB:ROUTe <Route>
The command selects the signal route for the baseband signal of a two-path instrument.
Parameters:
A|B|AB
A
The baseband signal is introduced into path A. The signals from
both paths are summed if necessary.
B
The baseband signal is introduced into path B. The signals from
both paths are summed if necessary.
AB
The baseband signal is introduced into path A and path B. The
signals from both paths are summed if necessary.
A
<Route>
*RST:
SOUR2:BB:ROUT A
the baseband signal of path B is introduced into path A.
Example:
SOURce Subsystem
To Next Page
Loading...
